CertExams.com Simulator Lab Exercises Answers

Configuring port priority

Description: This lab exercise demonstrates configuring port-priority for an interface on a switch.

Instructions:

1. Enter into interface configuration mode on SW1

2. Issue the command "priority <priority-value> to configure port-priority on the specified interface and verify using show command. Port-Priority can be between 0 and 240 in the increments of 16, default is 128, the lower the number, higher is the priority.

Note: Please refer to the CertExams.com Juniper Simulator software for complete lab with commands


CertExams Blog!  Certexams.com Facebook Page Certexams.com Twitter Page Certexams on YouTube