CertExams.com Simulator Lab Exercises Answers

Configuring VTP on 2960S Switch

Description :This lab exercise demonstrates configuring VTP on a 2960S Switch.

lab image

Instructions:

1. Configure SW1 with fast ethernet 0/11 interface and enable trunk line by issuing switchport mode trunk command

2. Enter into vlan database mode of SW1 and configure vtp server on SW1 and set vtp domain to certexams 

3. Configure SW2 with fast ethernet 0/11 interface and enable trunk line by issuing switchport mode trunk command

4. Enter into vlan database mode of SW2 and configure vtp server on SW2 and set vtp domain to certexams, and then create VLAN 30 and VLAN 100 on SW2

5. Confirm that the VLAN’s set on SW2 are seen on SW1

Note: Please refer to the CertExams.com Network Simulator software for complete lab with commands. 


Certexams.com Facebook Page Certexams.com Twitter Page Certexams.com Google+ Page