Description : This lab exercise demonstrates trunk concept in VLANs. i.e with trunk set up on only one of the the two switches and see that ping fails from R1 to WS1, correct the configuration by setting up trunk on both the switches and verifying the same.
Work station WS1 with IP Address 192.168.100.2/24 and a default-gateway
2. Configure Router R1 Ethernet interface with IP Address 192.168.100.1/24
3. Check ping from WS1 to R1 and see that it is successful
4. Configure SW1 with vtp domain cisco, password ccna and create VLANs 50, 60 and 70 on it
5. Issue show vlan and show vtp status commands and verify the configurations
6. Configure SW2 with vtp domain cisco, password ccna and create VLAN 50 on it and verify the same using show vlan and show vtp status commands
7. On SW1, configure port fa 0/1 to VLAN 50 and check the same using show vlan command
8. On SW2 also, configure port fa 0/1 to VLAN 50 and check the same using show vlan command
9. Now ping from WS1 to R1 and see that it fails as there is no trunk line enabled to carry traffic on any VLAN
10. Configure trunk on fa0/12 port of SW1 and now ping form WS1 to R1 and see that it fails because trunk is to be configured on both the switches to carry traffic
11. Now configure trunk on SW2 also on fa 0/12 port and issue appropriate show commands to check the same
12. Ping from WS1 to R1 and see that ping is now successful
Note: Please refer to the CertExams.com Lab Simulator For Network+ software for complete lab with commands.
Cert-Ex™ Exam Simulators, Cert-Ex™ Network Simulator, Cert-Ex™ Cheatsheets are written independently by CertExams.com and not affiliated or authorized by respective certification providers. Cert-Ex™ is a trade mark of CertExams.com or entity representing Certexams.com.Network+™ is a trademark of CompTIA® organization.