Description
: This lab demonstrates configuring and implementing default routes in
a network.
Instructions:
1.Configure R1 Ethernet interface with IP Address
192.168.201.1/24 and serial interface with IP Address 192.168.1.1/24 and
enable the interfaces
2. Configure R2 Ethernet
interface with IP Address 192.168.200.1/24 and serial interface with IP
Address 192.168.1.2/24 and enable the interfaces
3. Configure workstations WS1
and WS2 with the IP addresses and default-gateways as shown in the figure
4. Ping from R1 to R2, R1 to
WS1 and R2 to WS2 and see that they are successful
5. Ping from WS1 to WS2 and
see that it fails
6. Now set up default routes
on R1 and R2 using ip route command by specifying appropriate next hop
address
7. Ping from WS1 to WS2 and
see that it is successful and also verify that every device can ping any
other device
Note: Please refer to the CertExams.com Lab Simulator For Network+ software for complete lab with
commands
Cert-Ex™ Exam Simulators, Cert-Ex™ Network Simulator, Cert-Ex™ Cheatsheets are written independently by CertExams.com and not affiliated or authorized by respective certification providers. Cert-Ex™ is a trade mark of CertExams.com or entity representing Certexams.com.Network+™ is a trademark of CompTIA® organization.
