Description: Use the traceroute command to map the IP addresses that a packet travels through to get from one device to another.
IP Address Assignment Table
| Device | Interface | IP Address/Mask |
| R1 | E0 S0 |
192.168.10.2/24 |
| R2 | E0 | 192.168.10.1/24 |
| R3 | S0 | 192.168.20.2/24 |
Instructions:
1. Configure routers to the specification given above
2. Enable RIP routing across all three routers
3. From Router1, ping the directly connected routers and their interfaces which are Router2 ethernet0 and Router3 serial 0
4. You should be able to ping non-directly connected routers as RIP routing is enabled
5.
Next , the traceroute command is entered which helps in determining the
path of a packet to its
destination
Note: Please refer to the CertExams.com Lab Simulator For Network+ software for complete lab with commands.
Cert-Ex™ Exam Simulators, Cert-Ex™ Network Simulator, Cert-Ex™ Cheatsheets are written independently by CertExams.com and not affiliated or authorized by respective certification providers. Cert-Ex™ is a trade mark of CertExams.com or entity representing Certexams.com.Network+™ is a trademark of CompTIA® organization.
