Description: This lab exercise demonstrates the necessary commands to configure the root switch.
Instructions
1. Enter into configuration mode on SW1
2. Issue the command "spanning-tree vlan <vlan-num> root" that modifies the switch priority from the default 32768 to a lower value to allow the switch to become the root switch for VLAN 1
3. Verify the configuration using “show spanning-tree” command.
SW1>enable
SW1#configure terminal
SW1(config)#spanning-tree vlan 1 root
SW1(config)#exit
SW1#show spanning-tree
Cert-Ex™ Exam Simulators, Cert-Ex™ Network Simulator, Cert-Ex™ Cheatsheets are written independently by CertExams.com and not affiliated or authorized by respective certification providers. Cert-Ex™ is a trade mark of CertExams.com or entity representing Certexams.com.Network+™ is a trademark of CompTIA® organization.
