Description: You configure a few switch ports for duplex. Choose 2950 switch from the n/w diagram and exit. The following commands are used for configuring the switch ports.
Instructions:
1. Set the inter-switch communication to full-duplex on Switch S1, port fa 0/26
2. Set the port speed to 100 mbps, and inter-switch communication to full-duplex on Switch
S2 ports fa 0/1, fa 0/2, and fa 0/3.
3. Eixit to privileged mode.
4. Save the configuration to NVRAM.
2950>enable
2950#configure terminal
2950(config)#interface fa 0/1
2950(config-if)#duplex full
2950(config-if)#exit
2950(config)#interface fa 0/3
2950(config-if)#duplex full
2950(config-if)#speed 100
2950(config-if)#end
2950#copy running-config startup-config
Cert-Ex™ Exam Simulators, Cert-Ex™ Network Simulator, Cert-Ex™ Cheatsheets are written independently by CertExams.com and not affiliated or authorized by respective certification providers. Cert-Ex™ is a trade mark of CertExams.com or entity representing Certexams.com.Network+™ is a trademark of CompTIA® organization.
