Description: This exercise concentrates on establishing a trunk-line between the switches. The command used to configure trunking is switchport mode trunk.
Instructions:
1. Connect to SW1 and configure fast ethernet interface fa 0/11 on the switch
2 Configure trunking on the switch by issuing command switchport mode trunk
3. Connect to SW2 and configure fast ethernet interface fa 0/11 on the switch
4. Configure trunk line on the switch by issuing switchport mode trunk command
5.
Configure WS1 with IP Address 192.168.100.1/24 and WS2 with IP Address
192.168.100.2/24
Note: Please refer to the CertExams.com Lab Simulator For
Network+ software for complete lab with
commands.
Cert-Ex™ Exam Simulators, Cert-Ex™ Network Simulator, Cert-Ex™ Cheatsheets are written independently by CertExams.com and not affiliated or authorized by respective certification providers. Cert-Ex™ is a trade mark of CertExams.com or entity representing Certexams.com.Network+™ is a trademark of CompTIA® organization.
