CertExams.com Simulator Lab Exercises Answers

Router CDP Configuration

Description: This exercise helps in understanding Cisco Discovery Protocol commands . Set the cdp timer, holdtime and view configuration details. Show cdp interface command displays the status of all interfaces that are running cdp.

Instructions:

1. Type the command to see the status of all interfaces that are running CDP

2. Enable the serial 0/0 interface

3. Enable Ethernet 0 interface

4. Set CDP timer to to 30 seconds

5. Set CDP holdtime to 90 Seconds

6. Type the command to see the status of all interfaces that are running CDP

7. Disable CDP in Global Configuration Mode

R1>enable
R1#show cdp interface
R1#configure terminal
R1(config)#interface serial 0/0
R1(config-if)#no shutdown
R1(config-if)#exit
R1(config)#interface fastethernet 0/0
R1(config-if)#no shutdown
R1(config-if)#exit
R1(config)#cdp timer 30
R1(config)#cdp holdtime 90
R1(config)#exit
R1#show cdp interface
R1#configure terminal
R1(config)#no cdp run

Note: Please refer to the CertExams.com Network Simulator software for complete lab with GUI Interface.