CertExams.com Simulator Lab Exercises Answers

Introduction to IP

Description: This lab exercise is to learn assigning IP address to routers and pinging between them to test connectivity.


Instructions:

1. Connect to router R1, configure its terminal and set its hostname to Router1

2. Enter interface configuration mode for Ethernet 0 interface and serial 0 interface and set its IP addresses to 10.1.10.2/24, 172.16.20.1/24 and enable the interfaces

3. Connect to router R2, configure its terminal and set its hostname to Router2

4. Enter interface configuration mode for Ethernet 0 interface and set its IP address to 10.1.10.1/24 and enable the interface

5. Connect to router R3, configure its terminal and set its hostname to Router3

6. Enter interface configuration mode for serial 0 interface and set its ip address to 172.16.20.2/24 and enable the interface

7. Ping Router2ís Ethernet interface and Router3ís serial 0 interface from Router1

8. Use the command show ip interface brief to verify that the lines and protocols are up for all Router1ís interfaces

9. Display Router1ís running configuration to verify that the IP addresses appear

10. Display detailed IP information about each interface on Router1

Note: Please refer to the CertExams.com Network Simulator software for complete lab with commands. 

 

Real Time Web Analytics

Clicky