CertExams.com Simulator Lab Exercises Answers

Frame-Relay with show commands

Description : This is a basic lab exercise on frame-relay which showcases on frame-relay connection and show commands associated to frame-relay.

Instructions:

1. Configure Frame-Relay on R1 Serial 0 interface to an IP Address of 192.168.100.1 255.255.255.0 and enable the interface. Use frame-relay map statements for static mapping and use ANSI as its LMI type

2. Configure Frame-Relay on R2 Serial 0 interface to an IP Address of 192.168.100.2 255.255.255.0 and enable the interface. Use frame-relay map statements for static mapping and use ANSI as its LMI type

3. Use show interfaces serial 0 command on R1 and R2 in order to check that the routers are successfully connected to their frame-relay network. See that in the output, the encapsulation type is Frame-Relay

4. Issue show frame-relay map command on R1 and R2 which displays the mappings of local DLCIs to remote IP Addresses

5. Issue show frame-relay lmi command on R1 which displays the Local Management Interface statistics

6. Issue show frame-relay pvc <dlci-num> command on R1 and R2 which displays the permanent virtual circuit (PVC) mappings for the router.

7. Ping from R2 to R1 and check connectivity

Note: Please refer to the CertExams.com Network Simulator software for complete lab with commands.