Configuring
Ethernet Interfaces on a Router Network
Lab
Index |
|
|
I. Title: Configuring
Ethernet interfaces on a router network.
II. Description: The purpose of this Lab is to configure
Ethernet interfaces on two routers connected through a switch.
Network
Diagram
III. Instructions:
Router R1
1)Assign the IP address on Ethernet E0 as given below
| Device |
Interface |
IP Address |
Mask |
| R1 |
E0
|
172.16.1.1
|
255.255.0.0
|
2)Enter appropriate interface description.
3. Make the interface
up
Router R2:
1. Assign the IP
address on Ethernet E0 as given below:
| Device |
Interface |
IP Address |
Mask |
| R1 |
E0 |
172.16.1.2 |
255.255.0.0
|
2. Enter appropriate
interface description
3. Make the interface
up
4. Exit to global
configuration mode and issue ping command to interface 172.16.1.1
and verify that you get ping response. A successfull ping response
represents connectivity between the two Ethernet interfaces.
IV. Commands:
On R1:
R1>enable
R1#configure terminal
R1(config)#interface ethernet 0
R1(config-if)#ip address 172.16.1.1 255.255.0.0
R1(config-if)# no shutdown
R1(config-if)#exit
On R2:
R2>enable
R2#configure terminal
R2(config)#interface ethernet 0
R2(config-if)#ip address 172.16.1.2 255.255.0.0
R2(config-if)# no shutdown
R2(config-if)#end
R2#ping 172.16.1.1
